BINZEL-ABICOR 881.3112, Operating Instructions Manual

Page: 47 / 108

M-Drive 9 Maintenance and cleaning
EN - 21
9.1 Maintenance intervals
Observe the instructions of the guideline EN 60974-4 Inspection and test during the operation of arc
welding equipment as well as the laws and guidelines valid in the respective country.
Check the following:
NOTICE
• The maintenance intervals given are standard values and refer to single-shift operation.
1 Wire inlet
2 Grub screw
3 Connection nipple
4 Masterliner wire outlet
5 Quick coupling
6 Nut
7 Wire guide tube
8 Screw
Fig. 15 Maintenance and cleaning
1 2 3
4
5
6 7 8
Weekly Monthly Every six months
Visual inspection of the wire inlet and wire outlet liner. In case of wear,
replace as follows:
• Undo the screw (8) , replace the wire inlet (1) and secure with the
screw (8) again.
• Check that the
connections (cable
assembly, control lead,
ground) are secure.
Tighten if necessary.
• Remove the side panel.
Air blast the housing
interior using dry
compressed air to
remove any dirt.
Visual inspection of the Masterliner wire outlet (4) . In case of wear,
replace as follows:
• Release the wire outlet (4) from the quick coupling (5) . Undo the
nut (6) from the wire outlet (4) . Replace the connection nipple (3) and
the plastic liner then secure again with the nut (6) . Insert the wire
outlet (4) into the quick coupling (5) .
Tab. 11 M-Drive maintenance and cleaning