N
ET
RACER
22
Setting up the ISDN Interface
Select [
CM-1BRI, ISDN S0
] to configure your ISDN inter-
face.
Depending on which protocol your ISDN subscriber in-
terface uses and whether or not the ISDN autoconfigura-
tion was successful, the [
CM-1BRI, ISDN S0
] menu may
be displayed as follows:
The ISDN autoconfiguration procedure runs until ei-
ther the proper protocol is detected or the switch type is
set manually. If the cables are connected and auto detec-
tion just keeps running, you may have to select the appro-
priate ISDN protocol manually by scrolling through the
entries in the
ISDN Switch Type
field using the spacebar or
the left and right arrow keys.
Leaving the Switch Type setting to “autodetect on
bootup” usually allows the NetRACER to automatically
detect the proper ISDN protocol each time the system
boots.
NetRACER Setup Tool
BinTec Communications AG
[WAN]: WAN Interface
mynetracer
Result of autoconfiguration:
Euro ISDN, point to point
ISDN Switch Type
autodetect on bootup
Country Code
49
Area Code
911
Subscriber Number
1234
Advanced Settings >
SAVE
CANCEL
Use <Space> to select
