lems of drivers and other components.
3.4.2 Connecting
• Ensure that the on/off power supply switch is in the OFF position.
• Connect all data cables.
• Connect the power supply to the device.
• Set the device’s on/off power supply switch in the ON position.
3.4.3 Disconnecting
• Set the on/off power supply switch in the OFF position.
• Disconnect the power supply from the device.
• Disconnect the data cables.
To connect the power source to the device, follow the steps listed in the previous table: ensure that the switch is OFF
(0) and the power supply is NOT connected to the main electricity supply; find the POWER plug (located on the rear
panel of the device) and plug it into the power source using the grounded cable that is supplied for this purpose.
3.5 RESET Button
The different features of the RESET button are described below.
3.5.1 Rebooting the device
Once the device is operating normally, pressing the RESET button will make it restart.
3.5.2 Default Configuration
The RESET button allows you to boot the device with its default configuration through the following steps:
• With the device switched off, keep the RESET button pressed and switch on the router through the ON/OFF switch
(1).
• The STATUS LED (green) will light up and the USB LED will begin to blink (green). This blinking will continue for
10 seconds.
• For the device to boot with the default configuration, stop pressing the RESET button while the USB LED is blink-
ing, i.e. before the 10 second period expires.
The default configuration for the router establishes the access IP and mask address as follows:
• IP address: 192.168.1.1
• IP mask: 255.255.255.0
Note
Some devices leave the factory with customized settings. This personalization may mean that the de-
fault configuration is different from the one shown above.
3.6 Connecting the data
The RS123 router family has the following data connections.
3 Components and Power Supply
bintec elmeg
12
RS123 Router
