The required notch is located on the rear side of the housing.
3.3 Plug-in Modules
The only module that can be inserted in the device is the 3G USB modem. To view the list of supported 3G modems,
please visit the following website: http://www.bintec-elmeg.com.
3.3.1 Installation
To install the USB modem, simply insert it in the USB slot on the front panel as shown in the following figure:
Fig. 9:
USB modem insertion slot
3.3.2 Uninstall
To remove the device, simply remove it from the slot where it was inserted.
3.4 Power Source
The RS123 router is powered with an internal power source.
Workplace Conditions. Main Characteristics
• Excessive cold and heat should be avoided, as should humidity and dust.
• Direct exposure to sunlight should be avoided, as well as other heat sources. The device should not be placed
amongst papers, magazines or other elements that could hinder natural air circulation.
• The device should not be placed very close to strong electromagnetic fields such as speakers, engines, etc.
• Knocks and/or strong vibrations should be avoided during transport, operation and storage.
Warning
The electric current in power cables, telephone lines and communication cables is dangerous. To pre-
vent electric shocks, before installing, handling or opening the equipment covers, connect and discon-
nect the cables following the steps set forth in
Connecting
on page 12 and
Disconnecting
on page 12.
3.4.1 Connecting to the power source
To connect the power cable to the device, follow the steps set forth in section
Connecting
on page 12.
Warning
To avoid electric shocks, residual current circulation and other unwanted effects, also affecting commu-
nications, the following is recommended:
All interconnected communication devices should be plugged to THE SAME GROUNDED POWER
OUTLET, which should at the same time be of good quality (lower than 10 ohms).
Whether the workplace is provided with an uninterrupted power supply system (UPS), regulated supply
or it is independent from the rest (such as lighting, etc.); it is highly recommended that all data devices
should be connected to the same power source. This will avoid operating and premature aging prob-
bintec elmeg
3 Components and Power Supply
RS123 Router
11
