BINMASTER DPM-100, Instruction Manual

Page: 50 / 68

DPM-100 Digital Panel Meter Modbus ® Display
Instruction Manual
50
Advanced Features Menu & Display Messages
Display Parameter
Action/Setting
Set 1
* Set Points 1-8
Set Points 1-8
Rly d
Relay Disable
Relay Disable
(all relays)
Rly e
Relay Enable
Relay Enable
(all relays)
O Hold
Output Hold
Output Hold (all relays)
d Hold
Display Hold
Display Hold
(while held low)
disabl
Disable
Disable
Contrl
Manual
Control
Manual Control menu
dI 1*
DI 1-8
*Digital Inputs 1-8
nmenu
Menu
Menu
right
Right
Right
up
Up
Up
enter
Enter
Enter
F on 1
* Force On
Relay 1
*Force On Relay 1-4
dO 1
* DO 1-8
*Digital Outputs 1-8
Alnm 1
* Alarm 1-8
*Alarm 1-8
Ack
Acknowledge
Acknowledge
reset
Reset
Enter Reset menu
Rst Hi
Reset Max
Reset Maximum
Rst Lo
Reset Min
Reset Minimum
Rst HL
Reset Max-
Min
Reset Maximum &
Minimum
disabl
Disable
Disable
diag
Diagnostic
Enter Diagnostics
menu
reset
Reset
Reset to Factory
Defaults
Led t
LED Test
LEDs cycle through all
digits, decimal points,
and indicators
info
Info
Displays Scanner
information
sft
Software
Displays
Software
information
Ver
Software
Version
Displays Software
Version information
Scan Function (
SCan
)
The
Scan
menu is used to program the PV scan
mode and the scanner’s behavior on alarm condition.
The operator is able to scan automatically based on a
time parameter, or scan manually with front panel
keys or digital inputs. The operator is also able to set
the scanner to stop on alarm or continue scanning on
alarm. To resume scanning the operator must press
the Next or Previous button. Please follow the menu
below for details. In the Stop on Alarm mode, the
scanner will go to the alarmed PV and remain there
until the operator manually advances to the next PV
or returns to the previous PV. If a new alarm is
detected the process is repeated. The scanner
ignores old alarms.
Manual Control Menu (
Contrl
)
The Manual Control menu is used to control the
4-20 mA analog output and the relays manually,
ignoring the input. Each relay and analog output can
be programmed independently for manual control.
Selecting automatic control sets all relays and analog
output for automatic operation.
Continues
to
Control Menu.
Once Manual mode is initiated on any relay or
analog output, an LED labeled “M” is turned
on. Every few seconds, all LEDs representing
outputs that are in Manual mode, as well as
the “M” LED flash. This process will continue
as long as any output is in manual mode.
To
FILTER
Menu
To
Relays 2-8