7
SECTION 3.1 – TYPICAL INSTALLATION
14
1
8
1
7
1
6
1
5
1
3
11
1
0A
1
2
1
0
9
8
7
6
5
4
3
2
1
The general arrangement of a typical installation as
depicted in the diagram is advisory only.
Be sure to mount the pump securely and to position the
pump above the floor at a convenient height to allow for
maintenance, visual observation, and periodic inspection.
Use a compatible thread compound on all tapered male
pipe threads to guard against leakage and to lubricate
threads for assembly.
The wall mount bracket is included with all Exel pumps.
Pump geometry positions air valve and outlet manifold to one
side, allowing wall mounting without the need for a shelf.
1. Oil-water extractor
2. Piping circuit to avoid scale and resolve
3. Air valve bleed type master
4. Oil-water extractor
5. Regulated air pressure gauge
6. Air regulator self relieving
7. In-line oiler
8. Air valve bleed type shut-off
9. Grounded air supply line
10. Automatic drain
10A. Automatic drain-away hosing
11. Pump protector device
12. Outlet filter
13. Grounded fluid line
14. Pressure relief-drain valve
15. Pressure relief-drain hosing
16. Siphon tube hosing with spring guard (optional)
17. Hosing/piping from gravity supply (optional)
18. Ground wire connected to ground source
NOTE
The mounting of the pump to a vertical surface or wall may
require reinforcement back-up. Please contact your Binks
Representative for assistance in planning your system. Be
sure that you comply with all federal, state, and local codes
before installation.
