Binatone EEJ1555, Instruction Manual

Page: 9 / 38

11
ENGLISH
fresh water to the MAX fill level and place an empty cup on the
drip tray.
10. Set the on/off switch to the on position and wait for the water
to be dispensed into the cup.
11. Discard the water in the cup.
12. Repeat steps 10 and 11 until the water level is at the MIN
mark. Open the lid and empty any remaining water into the
sink (see the section «
DE-SCALING THE APPLIANCE» ).
Any other works should be performed in the authorized ser-
vice center.
Do not store the appliance if it is hot or connected to the
network. If you do not use the appliance, put it in a box after
cooling and store in a safe, dry place, out of children’s reach.
List of possible problems:
Problem
The power on/off
switch can not be
fixed in the operation
position
No backlighting in
the water con-
tainer. The
appliance doesn’t
heat water
The appliance boils
non-full cup of water
Large amount of
steam during the boil-
ing process and the
absence of water in
the cup
During the boiling
process the power
on/off switch was
pressed, but the pro-
cess of boiling hasn’t
stopped
The appliance makes
some noise; after boil-
Possible cause
The appliance hasn’t
cooled down after
the last use
The appliance is not
connected to the
mains supply
The appliance is po-
sitioned incorrectly
on the base
Safety cut-off is burnt
No water in the ap-
pliance
Excessive level of
scale
Water level is below
the minimum marking
Excessive level of
scale
The appliance boils
the fixed amount of
water (250 ml). The
capacity is not ad-
justed manually.
When the tempera-
ture of water reaches
a certain point, wa-
ter is automatically
poured into the cup
After the boiling pro-
cess is finished you
Solution
Wait a little and try
again
Check the connec-
tion of the appliance
to the mains supply
Check the correct
positioning of the ap-
pliance
Consult service facil-
ity
Let the appliance
cool down, then fill it
with water
De-scale the appli-
ance
Maintain the proper
water level inside the
water container (be-
tween the minimum
and maximum
marks)
De-scale the appli-
ance
Wait for the boiling
cycle to finish and let
water pour into the
tray for drops. Wait
for water to cool and
pour it out of the tray
This is normal