14
6.6. Thread-Locking Power Connector
This extender pair is Power over Cable capable and therefore can be powered from either
the transmitter or receiver. When a power supply is connected to either the transmitter or
receiver, the HDBaseT link sends power to the other end.
CAUTION: DO NOT
connect the power supply to the device until it is completely
installed and all connections have been made.
6.7 Optional Remote Power (Receiver Only)
Power for the B-520-EXT-230-RS-W receiver can be supplied via a remote power source when
use of the Latch-Locking Power Jack is not desired. The connection is a 2 conductor removable
plug located on the rear of the B-520-EXT-230-RS-W receiver. The recommended cabling is
one 18 gauge per leg or two 22/ 24 gauge per leg.
Observe the connections polarity markings. Reversing the polarity may cause damage to the
product.
FIGURE 14: Remote Power Pin Out
The included WPS-ACC-PWR-DC Power Plug can be used to convert the single plug of a power
supply to 2 wires. This eliminates the need to cut the wires on the end of a power supply.
FIGURE 15: Power Plug
+ (POS)
- (GND)