10
ATTENTION!
The installation and location of the appliance must be in accordance with the regulations on
the prevention of risks and safety at work (regulatory standard in force in your country).
The manufacturer will not be responsible for possible direct or indirect damage caused by
non-compliance with said standards and other instructions presented in this manual.
3.2. Electrical connection
The equipment comes with a power cord to be plugged into an electrical outlet. If the power
cord is damaged, it must be replaced with a new one. The exchange must be made by the
manufacturer, authorized agent or a qualified person in order to avoid risk.
The type of plug of the power cord varies by country. The installation of the equipment must
be carried out by a qualified technician for this role and in accordance with the current regulations of
the country, especially with regard to the ground connection (if applicable).
An equipotential ground terminal, located on the easel, is supplied with the appliance (image
below)
.
The post identified in the figure below is an additional protection for the
grounding that is provided in the mains, it must be connected to a
grounding terminal bar, regardless of the connection to the mains, and other
products that have accessible metallic parts. And which are stationary, must also be
connected to this bus as well as the service bench itself, in case it is of metallic material . As
such, all these products will be under the same electrical potential avoiding undesirable
leakage current.