-17-
10. Cleaning, maintenance and repair
10.6 Bleeding the hydraulic system
Air may find its way into the pump during transportation, tilting or usage on uneven
ground. It can result in not elevating forks while pumping in the “lift” position. The
air can be removed in the following way:
1. Move the control handle to the “lower” position, and then move the tiller down
several times. Thereafter normal operation can be resumed.
10.7 Adding hydraulic oil to the pump reservoir
1. Make sure forks are in lowered position.
2. Lay the product on either side. Position the drain plug of hydraulic cylinder up.
3. Remove the screw plug.
4. Add hydraulic oil until level of oil is at bottom of the hole.
5. Change oil (more frequently if colour has substantially darkened or feels gritty).
The required hydraulic fluid type is ISO VG32, its viscosity should be 30 cSt at
400°C, total volume is about 0.3 I.
6. Replace drain plug, upright the product.
11. Storage and transportation
11.1 Storage
1. Clean the product as described above.
2. Remove the load and lower the product to its lowest position.
3. Store the product in a dry, frost-free place. Protect it from any kind of moisture.
4. Always store the product in a place that is inaccessible to children. The ideal
storage temperature is between 10°C and 30°C.
5. We recommend using the original package for storage or covering the product
with a suitable cloth to protect it against dust.
NOTE:
Before using it again, use this instruction manual to check
the product for possible wear and damage.
11.2 Transportation
1. Remove the load and lower the product to its lowest position.
2. Lash it safe with dedicated lashing straps.
(IM)237‐000413_RHP25_GB-IM_V4_150626.indd 17
7/3/15 17:09
