-11-
7. Before use
5. Set the control lever (4) to the “lift” position. Raise the swing rod (8) and insert
the adjusting bolt (i) into the slot, with one nut each underneath and above the
swing rod (8).
6. Move the nuts on the adjusting bolt (i) close to the swing rod (8) so that it
cannot fall out of the slot. Do not tighten against each other!
7. Adjust the swing rod (8) (
→
7.3 Swing rod adjustment).
7.3 Swing rod adjustment
The control lever (4) on the tiller (3) and the swing rod (8) are linked to each other
and move respectively in the following three positions:
Control lever
Swing rod
Action
Position
Lower
(pull and hold)
Neutral
(set before moving)
Lift
(set before pumping)
Adjust the swing rod according to following steps if necessary:
1. Set the control lever (4) to the “lift” position.
2. Turn the adjusting screw (e) on the swing rod (8) clockwise until it has contact
with the hydraulic valve unit (f) on the pump unit (2). Do not apply pressure!
3. Check if all three positions of the control lever (4) and the swing rod (8) are
working properly.
4. If the forks (5) elevate while pumping in the “neutral” position, turn the adjusting
screw (e) on the swing rod (8) clockwise until pumping action does not raise
the forks (5) and the “neutral” position works properly.
5. If the forks (5) descend while pumping in the “neutral” position, turn the
adjusting screw (e) on the swing rod (8) counter-clockwise until the forks (5)
do not lower.
(IM)237‐000413_RHP25_GB-IM_V4_150626.indd 11
7/3/15 17:09
