Billion BiPAC 7300M, Quick Start Manual

Page: 8 / 19

Quick Start Guide
4
Hardware Overview – BiPAC 8200N Wireless-N VDSL2 Firewall Router
The Front LEDs
The Rear Ports
*Note 2: For WPS configuration, please refer to the WPS section of User Manual.
Lit green when the system is
ready. Lit red when the device
is booting. Flashes when the
system is rebooting or
firmware upgrading.
Lit green when a wireless
connection is established.
Blinking when data is
transmitted/received.
Lit green when the
device is successfully
connected to a VDSL
DSLAM. (“line sync”)
Lit when one of LAN ports is
connected to an Ethernet device.
Lit green when the speed of
transmission hits 100Mbps; Lit
orange when the speed of
transmission hits 10Mbps.Blinking
when data is transmitted/received.
Lit green when a wireless
connection is established.
Blinking when WPS
configuration is in progress.
Lit red when WAN port fails to
get IP address; Lit green when
WAN port gets IP address
successfully. Lit off when the
device is in bridge mode or
when WAN connection absent.
Connect this port to the
VDSL/telephone network
with the RJ-11 cable
(telephone) provided.
Press this button for
more than 1 second to
restore the device to its
default mode.
Connect it with the
supplied power
adapter.
Push this button to
trigger Wi-Fi Protected
Setup function.
*2
Power ON/OFF
switch. Connect the detachable
antenna to this port.
Connect a UTP Ethernet cable
(Cat-5 or Cat-5e) to one of the
four LAN ports when connecting
to a PC or an office/home
network of 10Mbps or 100Mbps.