Billion 810VNTX Router
Page | 33
Ethernet
The router supports more than one Ethernet IP address. The LAN allows multiple
PC‟s to access the internet at the same
time. Users usually only have one subnet in their LAN. The default IP address for the router is 10.0.0.2.
Primary IP Address:
IP Address:
The default IP on this router.
Subnet Mask
: The default subnet mask on this router.
RIP:
RIP v1, RIP v2, and RIP v2 Multicast. Check to enable RIP function.
IP Alias
This function enables the creation of multiple virtual IP interfaces for this router. It helps to connect two or more local
networks to the ISP or remote node. In this case, an internal router is not required.
IP Address
: Specify an IP address for this virtual interface.
Netmask
: Specify a subnet mask for this virtual interface
.
Security Interface
: Specify the firewall setting for this virtual interface.
Internal
: This means the network is behind NAT. All traffic will do network address translation when sending out
data to the Internet if NAT is enabled.
External:
This means there is no NAT on this IP interface and it is connected directly to the Internet. This
function is mostly used when you are provided with multiple public IP addresses by the ISP. In this case, you can
use the public IP address in the local network whose gateway IP address points to the IP address on this
interface.
DMZ
: Specify this network to a DMZ area. There is no NAT on this interface.
Summary of Contents for 810VNTX
Page 1: ......
