Bilanciai BTEK BS-FECD-P-CPD-M, Installation Manual, Page: 19 / 26

2016 www.B-TEK.com Pit Type Truck Scale Installation Manual 19
Wood safety blocking under weighbridge modules
Once the dummy load cell stand has been removed, replace with the load cell. Assembly per the diagram below:
Start by placing the ceramic isolation
disc into the circular ring which is part of
the locating plate. The load cell bottom
cup is then placed inside the isolation
disc, with the anti-rotation pin insert into
the cup’s blind hole.
Using the supplied tube of grease,
spread a moderate amount of grease
on the top button of the load cell bottom
cup.
Slide the foam ring over the top of the
load cell bottom cup, aligning with the
antirotation pin that is protruding.
Place the load cell onto the assembly,
taking care that thenotch in the bottom
of the load cell aligns with the anti-rota-
tion pin. The cable connector on the load cell should face the center of the scale towards the conduit.
Using the supplied tube of grease, spread a moderate amount of grease on the top button of the load cell where it
fits into the recess of the mounting plate.
Slowly release the jack to lower the module, with the load cell top cup’s button seating in the thru hole of the mod -
ule’s mounting plate.