Bil-Jax 45XA, Operator'S Manual

Page: 15 / 52

2 – BEFORE OPERATION
WEEKLY SERVICE CHECKS MONTHLY SERVICE CHECKS
Perform the following service checks at least once
each week in addition to all recommended daily
service checks:
Check Battery electrolyte level.

If battery electrolyte level is low, add enough distilled
water to bring the electrolyte level to the top of the
plates.

If batteries are fully charged, raise electrolyte level to
full mark in each cell.
Inspect all electrical wiring.

Check for cuts, loose terminals, broken wires, chaffing
and corrosion.

Repair all damage, remove corrosion and seal
exposed connections.
Inspect transport hitch components for damage.
Inspect boom lift for missing, loose or damaged
hardware.

Repair or replace as necessary.
Inspect all hydraulic system components
including pump and motor and cylinders for
damage, leaks, loss of pressure or speed, and
unusual noise or vibration.

Repair or replace as necessary.
Perform the following service checks at least once
each month in addition to all recommended daily
service checks:
Clean all battery terminals.
Check battery for loose connections or damaged
wires.
Verify proper operation of manual lowering
valves and hand pump

Refer to Section 3 for manual boom operating
procedures.
Lubricate all compartment hinges and latches,
slew ring and mating gear.

Use NLGI Grade 2 multi-purpose grease.
Check wheel nut torque.

Refer to Figure 2-3 for correct wheel nut tightening
sequence.

Evenly tighten wheel nuts to 34 N*m in the tightening
sequence shown.

Repeat sequence, tightening wheel nuts to 81 N*m
and to 136 N*m.
NOTE: Follow this procedure each time the
wheel is removed and reinstalled.
4
5
1
2
3
Figure 2-3. Wheel Nut Tightening Sequence
13