SADDLE INSTALLATION
SADDLE INSTALLATION
Once you have
installed
your REVIVE seatpost
into
your seat tube
you will need to install your saddle. Unscrew the two saddle head
clamp bolts, barrel nuts, upper and lower floating clamp using a
T25 Torx
wrench
(4mm Allen key on older versions)
.
Head Clamp Bolts
Lower Saddle
Clamp
Upper Saddle
Clamp
Barrel Nut
Barrel Nut
To install the saddle, replace the two saddle head clamp bolts,
spherical nuts, upper and lower floating clamp in the order in
which they were removed.
Before tightening, place the rails of your saddle between the
upper and lower saddle clamps so that the rails
rest
in the
channel provided by the lower floating clamp.
REVIVE saddle clamp is compatible with standard rails, oval
rails and carbon rails.
T
ighten the two head clamp bolts until the desired saddle
angle is achived. Then tighten both bolts evenly to a maximum
torque of
7
Nm
. Make sure, that the shaft or thread of the bolts
do not contact the post and cause bending of the bolts.
16
7
Nm
Torx T25
key
(4mm Allen key)
Head Clamp Bolts
7
Nm
Torx T25 key
(4mm Allen key)
