determine whether to stay on this channel. After 6 seconds, the headset
will scan for the next channel.
In rescanning channel mode, press [F] twice rapidly to store the scanned
channel. The headset will store channels in the order of Channel 1,
Channel 2, …, Channel 10. After 10 channels are store, old channels will
be replaced if newer channels are stored, also in the order of Channel 1,
Channel 2, …, Channel 10.
Note: when entering “rescanning channel mode”, ALOHA cannot receive
any Bluetooth signal. Please be sure to disconnect ALOHA from other
Bluetooth devices (cell phone, GPS, other ALOHA) when operating in
rescanning channel mode.
To save a channel, press [F] twice rapidly and hear "Save Channel".
2.
Rescan for channel/stop rescanning for channel: press [C] twice rapidly.
After turning on FM (but not in rescanning channel mode), press [C] twice will
enter rescanning channel mode. While in rescanning channel mode, press [C]
twice will exit the rescanning channel mode.
3. Next Channel, push [V] upward for 2 seconds and release
4.
Previous Channel, push [V] downward for 2 seconds and release
Adjusting FM Volume
Push [P] upward (to raise the volume) or downward (to lower the volume) on
ALOHA headset to adjust the radio playback volume.. During adjustment, a
double tone can be heard. When reaching the minimum or maximum volume,
a single <beep> tone can be heard. To adjust FM volume, the FM function
must be activated and in use.
11
Reset/erase Pairing Information
Power off the ALOHA headset when the ALOHA headset is ON. After the LED
indicator turns red, continue pressing the [A] button and press [C] ([A] and [C]
are pressed simultaneously). When the red light flashes 5 times, it indicates
that the pairing information has been reset/erased.