4
Screw (3x20mm)
2
PVC part
2
PVC part
1.5mm
Nut (3mm)
4
2
PVC part
2
PVC part
2
PVC part
1
PVC part
5
TP Screw (2.3x8mm)
Ply (15x15x3mm)
5
Epoxy plies inside the fuselage under the cowing and
mount the cowing with TP screw as illustration.
5
TP Screw (2.3x8mm)
Ply (15x15x3mm)
5
Steel wire
Aluminum tube
Clevis
Lock Nut (3mm )
Washer(3x15mm)
Screw (3x65mm)
3mm
120mm
15mm
2mm
Throttle servo
Elevator servo
Elevator servo
Rudder servo
Mounting of the receiver and the battery.
Trim the cowling for engine and muffler.
Assemble the cowling .
Connect the linkage rod to the horn.
The sketch map of the servos install completion
in the fuselage.
55
56
57
58
59
11
Accessory list for the coming installation steps.
Elevator
Make sure hinges are
mounted in the same line.
1mm
Tailing
edge
Make sure they are in
the right position while
installing.
Securely glue together. If coming off during flights, you 'll
lose control of your airplane which leads to accidents!
4mm
4mm
1
Rib template (3mm ply)
4
Wood dowel (4x30mm)
6
Pin hinge(24x24mm)
Assemble the rudder to the vertical tail with CA glue.
Apply instant type CA glue to elevator and pin hinge.
Keep some space with 1mm width between tailing edge
and elevator as below.
Assemble the elevator to the horizontal tail with CA glue.
Drill two holes at the stabilizer root base on rib template
and epexy the metal dowel in them.
A ccording to thr rib template drill holes to the tail of
fuselage as below.
28
29
30
31
32
6
27
