- EN 5 -
19
20
21
22
19. HEADPHONES JACK
20. BATTERY DOOR
21. AUX-IN JACK
22.
AC SOCKET
Start-up of the device/introduction
•
Select a suitable location for the device, such as a dry, flat, non-slip surface on which it is easy to
operate the machine.
•
Ensure that the device is sufficiently ventilated.
•
Remove the protective film from the display if it is still present.
Power Supply
•
Ensure that the voltage is the same as that indicated on the model identification plate.
•
Connect the power cable supplied (see battery compartment if necessary) to a properly installed
safety power socket and the mains connector AC on the back of the machine.
Inserting the Batteries (not supplied)
1.
Open the lid of the battery compartment.
2. Insert 6 batteries of type UM-2 (“C” size) 1.5 V. Please ensure that the polarity is correct (see the
floor of the battery compartment)!
3. Then close the battery lid.
NOTE:
•
When a mains cable is connected the batteries are automatically switched off.
CAUTION:
•
Batteries can leak and lose battery acid. When not using the system for a long period of time,
remove the batteries.
•
Do not dispose of batteries with household waste. Return old batteries to the respective collection
facilities or your dealer.
WARNING:
•
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like. Danger of
explosion!
Turning device on/ off
•
Press the “STANDBY / FUNCTION” button to turn the device on.
•
To turn off the device, keep the “STANDBY / FUNCTION” button pressed for approx. 3 seconds.
NOTE:
•
After about 10 minute without a signal, the device will automatically switch to standby.
Setting the clock
The system must be in standby mode in order to set the clock.
1.
Press and hold the “CLOCK / FM ST.” button for approx.2 seconds.
2. Use the “SKIP+ / ” & “SKIP- / TUNING-” buttons to set the time format “12 / 24hr”.
3. Press the “CLOCK / FM ST.” button to confirm time format.
