Big Joe EZ30, Operation, Maintenance, Repair Parts List

Page: 54 / 134

8-2 BL-EZ30-0815 - 07-28-2019
8-1.2. Repair
1. Remove pins (11, Figure 8-2 ), shafts (12) and
load wheel (13) from wheel brackets (8).
2. Remove pins (11) and shafts (10). Free brackets
(8) from tension bars (6).
3. Remove bushings (9) from brackets (8) if replace-
ment is necessary,
4. Remove clips (2) from link (1) and free tension
bars from link (1).
5. Loosen nuts (4) and remove clevises (5) from ten-
sion bars (6).
6. Remove bushings (3) from clevises (5) if replace-
ment is necessary.
7. Install reassemble by reversing the steps above.
8-1.3. Installation
1. Position the link assembly under frame (8).
2. Position wheel brackets (8, Figure 8-2 ) in frame
(8, Figure 8-1 ) and install shafts (6). Secure shafts
(8) with pins (7).
3. Raise the link (1, Figure 8-2 ) into position and
install shaft (9, Figure 8-1 ) through frame (8).
Secure shaft (9) with clips (3).
4. Position link (1, Figure 8-2 ) and install shafts (11,
Figure 8-1 ). Secure shafts (11) with pins (10),
5. Remove blocking and lower the truck to the
ground.
6. Turn on the key switch (20, Figure 12-20 ) and
emergency disconnect (17).
Figure 8-2 Lift Linkage Assembly
EZ30-12