44
Fig. 21.2
Fig. 21.1
Step 21: Attach Flange Assembly to Fort
Part 1
Hardware
14 x
#12 x 1” Pan Screw
4 x
#12 x 2” Pan Screw
8 x
#12 Screw Bezel
S7
(5 per side)
S6
A:
With a helper place the Flange Assembly flush to the top opening in (2622) End Panel Assembly as shown in
fig. 21.1, then pre-drill 1/8” pilot holes in (8935) Lower SL Insert for the 4 bottom mounting locations (approximate
spots where circles are on figure), making sure the pre-drilled holes are a minimum of 1” deep. (fig. 21.2)
B:
Attach Flange Assembly to (8935) Lower SL Insert using 4 (S7) #12 x 2” Pan Screws (with #12 Screw Bezel)
in the pre-drilled holes. (fig. 21.2) Make sure the flat surfaces of the Flange Assembly are flush to the (2622)
End Panel Assembly and (2602) Upper Jamb as shown in fig. 21.3.
C:
Attach the Flange Assembly flush to top of (2622) End Panel Assembly using 4 (S6) #12 x 1” Pan Screws
(with #12 Screw Bezel) and to (2602) Upper Jamb and side of (2622) End Panel Assembly using 5 (S6) #12 x 1”
Pan Screws per side. (fig. 21.2)
Flange
Assembly
w/ #12 Screw
Bezel
Top
Bottom of
slide flush with
(8935) Lower
SL Insert
Top of (2622) End
Panel Assembly
opening
Outside View
Inside View
2622
Top
Side
S6
S6
Side
2622
w/ #12 Screw
Bezel
S7
Flange
Assembly
Fig. 21.3
2602
8935
2602
8935
