BIG ASS FANS 8'-24' Powerfoil X, Installation Manual

Page: 31 / 72

8’ - 24’ POWERFOIL® X
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
25
WWW.BIGASSFANS.COM ©2011 DELTA T CORP. DBA BIG ASS FAN CO. ALL RIGHTS RESERVED
8’ - 24’ POWERFOIL® X
Wiring Data Cable for Wall Control
WARNING: Failure to install the adapter cable may result in damage to the fan or controller and void all warranty!
The patch cable can be configured to 568A or 568B wiring standards. A 5-ft patch cable is included with the wall control for testing
purposes prior to airfoil installation.
Mounting Wall Control
• Using the Mounting Plate as a template, mark the two screw locations and the one RJ-11 connector pass-through.
• Attach mounting plate to wall surface using BAF-supplied hardware (6-32 X 7/8” countersunk) and appropriate anchors. Connect
the control cable coming through the wall, and snap the wall control into the mounting plate.
• Mount the wall controller so that the fan(s) it controls is visible from wall controller location.
7.25” (18.4 cm)
3.85” (9.8 cm)
Depth: 1” (2.5 cm)
Ø .15" (1.4 cm)
2.83
.06
.66
.75
.250
1.26
2.88
.40
3.25
.40
.37
1.20
R.20
3.84
7.25
2.75
.15 THRU CSK
TO .28
(TYP. 2 HOLES)
A
A
B B
.97
Mounting Plate
(fits standard electrical wall box) Wall Controller
ATTENTION: To avoid damage to the VFD and fan controller, test
the VFD and fan controller with a test cable before wiring the CAT 5
cable!
The controller cable to be installed between wall controller and the fan
should be Category 5 or 5e cable. The distance limitation between the wall
controller and the Powerfoil X fan is 1000 feet.
The short adapter cable included with the fan’s wall control enables the
installer to use a CAT5 or CAT5e patch cable for communications between
the controller and the wall pad. The RJ-11 connector should be used on
the wall control end of the cable and the RJ-45 Connector should be used
on the fan end of the cable. Note: For the RJ-11, Brown and Orange/White
are not used.