19
Installation, Operation and Maintenance Manual
MAN 607 Rev. 6
February 2022
Section 3: Operation and Use
Operation and Use
For the adjustment of the mechanical stop on the end flange of cylinder, follow these
steps (Figure 18):
•
Remove with the specific wrench (c2) the plug of cylinder end flange.
•
Insert a wrench for Allen keys (c1) through the hole until reaching the
adjustment pin.
•
Turn counterclockwise to increase the angular stroke, turn clockwise to
decrease it.
•
When the adjustment is over, tighten the plug with the wrench c2.
Figure 18
Mechanical stop of the cylinder
Hydraulic Cylinder Diameter
Wrench C1 (mm)
Wrench C2 (mm)
From 16 to 28
8
19
From 28 to 40
8
22
From 45 to 60
12
27
From 70 to 175
14
36
From 200 to 235
22
36
From 235 to 300
22
36
Table 4.
