6. Lay the table upside down on the floor or on a bench.
7. Position the table leg (I) to the closed in corner of the extension
table (J) as shown in Fig. 11.
8. Attach the table leg to the table board with six 5/8” long wood
screws (K). Repeat this process for the remaining leg.
IMPORTANT: If your saw fence system will be used with a
mobile base underneath the saw base and table legs, the
position of the legs will have to be changed to fit the mobile
base extension.
NOTE: Table shown installed on a Unisaw without the cast iron
wing. If your saw has a cast iron extension wing on the right
hand side, it is not necessary to remove the wing. The
extension table can extend past the rails and tube.
9. Place table assembly (L) Fig. 12, in position between the two
rails, as shown. Make sure end of table is flush against saw table
(M). Using a straight edge make sure table (L) is in the same plane
and level with saw table (M). Lightly tap up or down and adjust leg
leveling screws. When you are certain table (L) is level and in the
same plane with saw table (M) tighten bar clamp (P) to hold
everything in position. Then drill 1/4” holes through the front and
rear of the extension table using holes (Q) provided in rails as a
template. NOTE: Number of holes (Q) in the front and rear rails will
vary depending on the length of the rails you purchased.
10. After the holes have been drilled in the edge of the front and rear
extension table board, fasten both front and rear rail to table using
the 1/4-20 x 1-1/2” flat head Phillips screws, 1-1/4” O.D. flat
washers and hex nuts (R).
11. Lay the guide tube (B) Fig. 14, on the saw table as shown, and
line up the threaded holes (S) on the bottom of guide tube with the
through holes (T) on the front rail.
NOTE: The guide tube should
extend past the rail 6” on each end.
12. Position the guide tube (B) on the front rail and fasten the guide
tube to the rail using the 1/4-20 x 1/2” long hex head screws and
lock washers. NOTE: Where there are two holes 2-1/2” apart, use
only one of the two holes.
PROCEED TO STEP ONE ON PAGE 9
Fig. 11
L
M
Q
P
R
Fig. 12
Fig. 13
6
B
S
R
Fig. 14
I
J
K
