I
NSTALLATION
C
OLD
ROOM
AIR
CURTAIN
en-10
en
2.3
General working methlod
2.3.1 Sequence of operations
Biddle recommends working as follows when installing the
unit:
1. Hang the unit up.
2. Install the control box.
3. Install any applicable external controls.
4. Connect the unit to the mains supply.
Caution:
c
Make sure that the unit’s power supply voltage
matches the local mains voltage.
The unit’s power supply voltage is displayed on the
type plate.
5. Complete the installation of the unit.
6. Switch the mains supply on and check that the unit is
working properly.
2.3.2 General instructions
Some parts of this section only apply to certain models.
Where this is the case, it will be indicated. If no specific model
is referred to, then the description applies to all models.
Note:
n
Make sure that you perform all installation
operations that are applicable to your unit.
Check the type plate and consult the manual if in
doubt about the model or type of your unit.
Note:
n
During the installation period, protect the unit
against damage and penetration of dust, cement, etc..
You can, for instance, use the packaging for
protection.
See also:
1.3.3 "Type designation" on page 5
1.3.4 "Type plate" on page 6
