Page 16 of 19 M7998 Issue 2.3
8. MAINTENANCE.
8.1. General Information and System Care.
Unplug the unit from the mains voltage supply and allow it to cool before undertaking
any maintenance tasks.
Maintenance should only be carried out under the direction of the Responsible Body, by a
competent electrician. Failure to do so may result in damage to the product and in extreme cases be
a danger to the end user.
With proper care in operation this equipment has been designed to give many years of reliable
service. Contamination or general misuse will reduce the effective life of this product and may cause
a hazard.
Maintenance for the unit should include:
•
Periodic electrical safety testing (an annual test is recommended as the minimum
requirement).
•
Regular inspection for damage with particular attention to the mains lead and plug set.
•
Routine cleaning of the equipment should be undertaken using a clean cloth.
DO NOT USE SOLVENTS FOR CLEANING ANY PART OF THIS EQUIPMENT.
8.2. Spillage and Decontamination.
8.3. There are no serviceable parts within the Intgrity-10 Unit, Multi-temp Box or IR box and
probes.
8.4.
Spillage and Decontamination.
If the equipment has been exposed to spillage or contamination, the Responsible
Body is responsible for carrying out appropriate decontamination. If hazardous material has
been spilt on or inside the equipment, decontamination should only be undertaken under
the control of the Responsible Body with due recognition of possible hazards. Before using
any cleaning or decontamination method, the Responsible Body should check with the
manufacturer the proposed method will not damage the equipment.
Prior to further use, the Responsible Body shall check the electrical safety of the unit. Only
if all safety requirements are met can the unit be used again. The above procedure is
intended as a guide. Should spillage occur with a toxic or hazardous fluid then special
precautions may be necessary.
Decontamination Certificate.
Note:
In the event of any part of this unit becoming damaged, the damaged item(s) should be
returned to the manufacturer for repair
accompanied by a decontamination certificate
.
Copies
of the Certificate are available from Distributor/Manufacturer. Appendix A of this
Instructions book may be copied and enlarged.
At the end of life this product must be accompanied with a Decontamination Certificate. See
page 19.
Summary of Contents for Electrothermal ATS10232E
Page 12: ...Page 12 of 19 M7998 Issue 2 3...
