BIAX MB 50, Translation Of The Original Operating Manual, Page: 9 / 16

Translation of the original operating manual
Drive unit for flexible shafts
– MB 50
OI NO.: 001 580 674 - 9 - of -16- Version 16.01.2020
GB
The operating unit with sheet (1) is fixed on the drive unit (5) at 4 points. For this purpose, the spacers (4) are
positioned between the drive unit and the sheet of the operating unit as shown in Figure 2; then they are secured
with the cylinder screws (2) and washers (3) included in the scope of delivery.
Figure 2: Mounting the operating unit on the drive unit
6.1.2 Mounting the Operating Unit for Bench Use
The supplied rubber-metal feet (3) are attached at 4 points. Each foot is bolted to the holder with a nut (1) and a
washer (2) as shown in Figure 3.
Figure 3: Mounting the Operating Unit for Bench Use
6.2 Setting Up
ATTENTION
– Danger of tipping!
When setting up the machine, make sure that the machine is standing securely and observe
the range of the flexible shaft!
The machine must not tip over when the shaft is pulled.