Biasi SG 2, Manual And Installation Instructions

Page: 5 / 40

Biasi SG Series
Page 5
IMPORTANT INFORMATION
Please read this page carefully.
•••• ALL BOILERS MUST BE INSTALLED IN ACCORDANCE WITH NATIONAL, STATE AND
LOCAL PLUMBING, HEATING AND ELECTRICAL CODES AND ORDINANCES, AS WELL AS
THE REGULATIONS OF THE SERVING ELECTRICAL, WATER AND GAS UTILITIES.
••••
All systems should be designed by competent contractors, and only persons
knowledgeable in the layout and installation of heating systems should attempt the
installation of any boiler. It is the responsibility of the installing contractor to see
that all controls are correctly installed and operating properly when the installation
is completed.
••••
Do not burn volatile garbage, gasoline, naphtha or other flammable liquids other
than No. 2 fuel oil. All flammable liquids (especially gasoline), chemicals, rags, paper,
wood scraps, debris, etc., should be kept away from the boiler at all times. Keep the
boiler area clean and free of all fire hazards.
••••
Please read the literature and warranties supplied by the manufacturers of the
various accessory equipment. This equipment is warranted by the respective
manufacturers, not by Quincy Hydronic Technologies, Inc. Each piece of equipment
must be installed and used according to the recommendations of the manufacturer.
Codes and Regulations:
Installation of the boiler, burner, oil tank and related equipment must conform to
national, state and local regulating agencies and codes applicable to the installation of the
equipment. In the absence of local requirements, the following codes apply:
The above codes are available from:
National Fire Protection Association (NFPA)
Battery March Park
Quincy, Massachusetts, 02269
http://www.nfpa.org
American Gas Association (AGA)
Pleasant Valley Road
Cleveland, OH 44134
http://www.aga.org
A. ANSI/NFPA - #31 Installation of Oil Burning Equipment
B. ANSI/NFPA - #70 National Electric Code
C. ANSI/NFPA - #211 Chimneys and Vents
D. ANSI/NFPA - #Z223.1 National Fuel Gas Code
E. ANSI/NFPA - Domestic Gas Conversion Burner
F. CAN/CGA - B149 Installation Codes
G. ANSI/ASME - CSD-1