Page 4 IV6-LAU Instructions I SERIES
LIGHT ARRAY FRAME ADAPTER U-BRACKET
The IV6-LAU
must
be used with the IV6-LAF-PBB Array Frame. It is designed
to support a variety of ancillary array mounting configurations and as a tool to
integrate IV6 arrays with I SERIES BalancePoint™ Flyware and other 3rd party
mounting systems.
Before assembly:
The IV6-LAU U-Bracket must be used with the IV6-LAF-PBB
to integrate with an IV6 array. Determine tilt angle and approximate center of
balance of the array for placement on the light array frame.
1.
Attach the U-Bracket to the IV6-LAF as shown (LAU-1). Insert bolts in the
"pivot" position first (see below) and then secure desired angle with the other
bolt. There is a slightly different connection for downfill applications - see LAU
Application #5.
Note:
In close surface mount applications, it is easier to mount the U-Bracket to the surface before
adding the IV6-LAF-PBB frame and loudspeakers.
IV6-LAU
LAU:
Light Array U-Bracket (1)
Hardware:
Qty
Code
Description
4
HHB-F 10.9 Flanged Hex Head
Bolts
4
HN-F Flanged Nuts
Kit Weight:
13.5 lbs (6.1 kg)
Working Load Limit:
500 lbs (226.8 kg)
(10:1 safety factor)
1
LAU-1.
Attach the U-bracket to the frame at the desired angle, centered around
the specified pin point# from EASE® Focus 3
HN-F
HHB-F
Rear
Front
Parts:
LAU
Center hole - for downfire applications
only - see Application #5 for connection
detail
15° tilt
10° tilt
Side view, 0° tilt
Pivot position
Pivot position
IMPORTANT:
When used with
the IV6-LAF-PBB to hold a
downfill loudspeaker at the bottom of
an array, the weight of the added
elements must be considered when
calculating the SWL of the array.
WARNING:
For safety reasons,
for the applications listed on the
next page, the center of mass of the
array
must
be located directly beneath
the IV6-LAF-PBB Frame. If the center
of mass is located behind the array
frame, it may result in an unsafe rigging
condition.
