Page 23
NEDSP1061-KBD Operating Manual
The NEDSP1061-KBD screened lead fits in the cut out
provided for the front antenna connector.
Replace the main unit, connections, and all screws
except the front right hand screw.
Drill the holes for the lid, as per the drawing on page 25
of this manual.
The keyboard is mounted using the supplied ‘Z’ bracket.
See page 25 for more information on installing the
bracket. Alternatively use hot melt, epoxy or any suitable
adhesive affix the small keyboard to the inside of the lid.
Taking care to not get adhesive on the upper surface of
the lid, switch or LED.
Allow this to cure before continuing.
Appendix A Y
aesu F
T-817.
Replace the main unit PCB.
Solder the red (power) lead to the drain of Q1082
(TP1084).
Connect M3 ring tag (0V leads) using the right front screw.
Affix the NEDSP1061-KBD module using the supplied
self adhesive pad in the chosen location.
The NEDSP1061-KBD can be
affixed in two positions.
The preferred position is in the
location of the optional filter. This
provides the more mechanically
secure location. If the optional filter
is (or is going to be) installed the module can be installed
on the inside of the lid (see photo).
