Page 14
NEDSP1061-KBD Operating Manual
The levels come factory set to the maximum position. This
should be adequate for most applications. However the
module can be adjusted as follows.
Tune the equipment to a strong signal.
Switch off the noise reduction (LED should illuminate
orange or red).
Adjust the input P2 until the overload led illuminates. Back
off the potentiometer approximately a 1/4 of a turn.
Adjust P1 to give the correct listening volume, without
distortion.
Adjust P3 to give the desired beep volume level, or off if
required.
4.
Setup.
4. Setup
