T5 Treadmill
BH Fitness • 20155 Ellipse • Foothill Ranch • CA • 92610
www.bhfitness.com • Phone 949-206-8152 • Fax 949-206-0013
11
MAINTENANCE CONTINUED
BELT SHIFTED TO THE RIGHT (Figure 8)
1. Turn off and unplug the treadmill each time before using the hex wrench.
2. Use the hex wrench to turn the right hexagonal head socket a 1/4 turn clockwise.
3. Turn on treadmill for a few minutes at a speed of 2.5 mph (4 km/h) and check belt location.
4. If the belt is not centered, then turn the left hexagonal head socket a 1/4 turn
counterclockwise.
5. If the belt is not centered, then repeat steps.
BELT SHIFTED TO THE LEFT (Figure 8)
1. Turn off and unplug the treadmill each time before using the hex wrench.
2. Use the hex wrench to turn the left hexagonal head socket a 1/4 turn clockwise.
3. Turn on treadmill for a few minutes at a speed of 2.5 mph (4 km/h) and check belt location.
4. If the belt is not centered, then turn the right hexagonal head socket a 1/4 turn
counterclockwise.
5. If the belt is not centered, then repeat steps.
TREADMILL CLEANING
Switch the unit off and unplug the power cable. Use a damp cloth or towel to clean the dust off
the treadmill, especially the side bars and the electronic console. Do not use solvents.
NOTE: Unplug the treadmill before using a vacuum near the treadmill.
Use a vacuum cleaner to carefully vacuum around the visible components (belt, structure,
etc.). You can vacuum the underside of the unit by increasing the INCLINE or folding up the
unit.
NOTE: Press STOP to lower the INCLINE.
TIGHTENING THE FASTENERS
Check the connections and tighten all the parts on your unit every three months.
Use of this machine with worn parts, e.g. the drive belt, running belt or rollers, may cause the
user injury. If you are unsure about the condition of any part, we recommend that you replace it
with original spare parts. The use of other spare parts may cause injuries or affect the
performance of the machine.
