SK9900RTV
Page 8
ASSEMBLY GUIDE
IMPORTANT:
The exercise machine is heavy. At least two people are required to ensure the safety of
those that are unpacking, installing and moving the equipment.
NOTE: For safety, maintain a minimum clearance around the equipment. Maintain 18 inches on
the front and each side plus 24 inches at the rear of the unit.
NOTE: Position on a level floor near a 110-120V dedicated electrical outlet.
1. ASSEMBLY INSTRUCTIONS
Figure 1. Take the unit out of the box and place it on the floor as shown in Figure 1. Verify
that the parts are undamaged and quantities are correct.
2. ATTACH THE MAIN POST
Figure 2. Take the post (A) and bring it up to the boss on the main body (B).
Connect the terminals (O and R), sticking out of the bottom of post (A), with terminal (P and
S) coming up out of the top of the tube on the main body (B).
Connect the terminals (s and v), sticking out of the bottom of post (A), with terminal (r and t)
coming up out of the top of the tube on the main body (B).
Slip the main post (A) over the boss on the main body (B), making sure not to damage any
of the cables.
Figure 2. Loosely fasten using flat washers (F), Grower spring washers (G) and screws (H).
Check alignment of post (A) and Body (B). Tighten the screws securely.
3. INSTALL THE BACKREST
Figure 2. Insert the backrest (E) into the tube on the seat.
Fasten using flat washers (LL), grower washers (L) and screws (K).
4. FIT THE FRONT TRIM COVER
Figure 3. Fit the front trim cover (C) by sliding it onto the side tubes. Install and tighten screw
(I) to secure the cover.
5. FIT THE TOP TRIM COVER AND BOTTLE HOLDER
Figure 4. Position the cover (D) so as to avoid hitting the Monitor. Move the cover (D) in the
direction of arrows (1), (2) and (3). Position the cover (D) over the side tubes of the main
body (B). Secure using screws (J).
Figure 4A. Remove the screws from the main post (B). Position the bottle holder (M) and
secure it by using the screws previously removed.
6. ADJUST THE SEAT
Figure 5. The seat position can be slid forwards or backwards by pressing lever (U)
upwards. Lever (U) is on the lower right side of the seat.
Release the lever to lock the seat into a position.
7. VIEW PULSE SENSOR
Figure 8. View the pulse sensors (Y) located on the handlebar. The users pulse rate is
measured by placing both hands on pulse sensors (Y).
8. LEVELING
NOTE: For safety, maintain a minimum clearance around the equipment. Maintain 18 inches
on the front and each side plus 24 inches at the rear of the unit.
Figure 6. Once the unit has been placed into its final position, make sure that it sits flat on
the floor and that it is level. Screw the adjustable support blocks (R) up or down to level the
unit.