BH FITNESS G840, Instructions For Assembly And Use

Page: 15 / 49

15
1. ASSEMBLY INSTRUCTIONS.-
1. Take the unit out of its box and make
sure that all of the pieces are there:
ATTENTION: The assistance of a
second
person is recommended
when assembling this machine
Fig.1 Parts list
(33) Left footrest .
(34) Right footrest.
(55) Main body.
(15) Front stabiliser bar with wheels.
(25) Rear stabiliser bar with
adjustable feet.
(52) Pedal right foot.
(53) Pedal left foot.
(102) Bottom focus bar, left.
(103) Bottom focus bar, right.
(9) Main post.
(3) Handlebar stem.
(100) Left focus bar or arm.
(101) Right focus bar or arm.
(27) Left footrest.
(28) Right footrest.
(1) Monitor.
(92) Handlebar embellishment cover.
(12) Axle
G842N:
(131) Transformer.
Fig.2 Screws and fasteners.
(79) Screw M-6x6.
(80) Screw M-8x55.
(81) Washer D8.
(82) Nut M8.
(83) Cap.
(84) Screw M-8x20.
(85) Washer D10.
(86) Washer D10.
(87) Washer D7,5.
(88) Washer D7,5.
(89) Washer D7.
(90) Washer D7.
(91) Screw M-7x30.
(93) Screw M-8x40.
(94) Washer D8.
(95) Screw M-8x50.
(96) Screw D16x16,5.
(97) Washer D8.
(98) Nut M8.
(99) Screw M-5x14.
Allen spanner, spanner Philips.
2. FITTING THE STABILISER
BARS.-
ATTENTION: The assistance of a
second person is required for this
stage of the assembly.
Bring the front stabiliser bar with
wheels (15) to the main body (55)
positioning the wheels at the front of
the unit, Fig.3, Insert the screws (79),
and tighten securely.
Carry out the same operation to attach
the rear stabiliser bar.
Take the rear stabiliser with adjustable
feet (21), and line up the dots, Fig.3.
Insert the screws (80) with the
washers (83) and tighten the nuts (82)
and tighten securely.
IMPORTANT: It is advisable to
retighten these screws after one
month of using the machine.
3. FITTING THE FOOT BARS.-
Then fit take the left foot (33) (marked
with the letter “L”) and insert the end
bush onto the drive spindle (E) on the
main body (55) Fig.4 with washer (36)
and the nut (35) and tighten
securely.Place the cap (54).
Take the right foot bar (34), (marked
with the letter “R”) and go through the
same assembly procedure as with the
left Fig.4.