16
the wall socket then change it for one
that matches, bearing in mind that the
earth wire must always be connected.
If in doubt, call BH technical services.
4
Never leave the unit unattended
when it is plugged in. Unplug it after
use.
5
Do not allow children or the disabled
to use the appliance without the strict
supervision of a qualified person.
6
Never use accessories not
recommended by the manufacturer.
7
Do not use the machine if the mains
cable becomes damaged or worn.
8
Keep the mains cable away from hot
surfaces.
9
Do not use the machine outdoors.
10
To unplug the machine, first put the
switch to the “0” position and then
unplug it from the wall socket.
SAFETY BREAKER.-
This model is equipped with an
electronic circuit breaker to protect
both the electronic and electrical
circuits.
This safety device will be
automatically triggered if the unit is
subjected to abnormal force or heat.
Should this occur:
1.-
Set switch (L), located on the
casing, to the “0” (OFF) position.
2.-
Press the circuit button (C) to reset
the unit.
3.-
Next, set switch (L) to the “I” (ON)
position and the unit will be ready for
use again.
Should the circuit breaker trip
repeatedly then the most probable
causes are:
- Abnormal working conditions,
- Treadmill belt in need of lubricant,
- Solvent based lubricants used (use
BH type),
- Belt is too tight.
Plug the unit into a wall socket with an
EARTH terminal. Set switch (L) to
Position [1]
Fig.B.
Fig.B
ASSEMBLY INSTRUCTIONS.-
Take the unit out of the box and place
it on the floor as shown in Fig.0.
The assistance of a second person
is advisable for the assembly work.
Make sure that all of the pieces are
there:
(B) Main structure; (2) Side bar base
cover (Left); (3) Side bar base cover
(Right); (10) Handrail cover (left); (11)
Handrail cover (right); (94) Allen screw
M8x95; (43) Allen screw M8x45; (95)
Flat washer M-8; (39) Spring washer
M-8; (50) Mains cable; (99) Allen key
5mm; (100) Allen key 6mm; (102)
Safety key; (83) Bottle of lubricant;
(84) Bottle.
Follow the instructions step by step to
assemble. At least two people are
needed for this step.
When fitting the side bars, one person
should hold the side bar while the
other one tightens the screws (94) and
(43).
This will prevent any possible
accidents.
1.-
First take hold of the handrails (G
and H) and lift them in the direction of
the arrow, as shown in Fig.1 and use
screws (43) to secure them.
Summary of Contents for G-6445N
Page 2: ...Fig 0 Fig 1 Fig 2 ...
Page 3: ...Fig 3 Fig 5 Fig 5 Fig 5 A ...
Page 4: ...Fig 6 Fig 7 Fig 8 ...
Page 67: ...67 G 6445N ...
