SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.l
h
a
t
s
w
s
@
o
f
n
i
:l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
INSTRUCTIONS
A
Use this tool to hold the Crankshaft Pulley Flange still whilst
releasing the pulley flange centre bolt (left hand thread). In
order to gain access to the pulley flange the pulley must first
be removed by removing the 4 outer fixings pulley fixings.
Note:
Do not release the pulley flange centre bolt until the
cam and crank timing pins are in place.
Do not attempt to loosen or tighten the pulley centre bolt with
out holding the flange with the flange tool or the crankshaft
and camshaft tools will be damaged.
D
The Timing Chain tensioning tool is used to clamp the timing
chain when replacing the gasket on the one-piece cylinder
head. The tool is attached in alignment with the inspection
opening on the engine control cover so that the pin acts upon
the ribs of the chain slider. Retract the chain tensioner piston
so that it moves back to its locked position using the lever.
Ensure the tensioner has fully extended before attempting to
retract it.
C
These camshaft locking tools are used to lock the camshafts
in position.
Access must first be gained to the blanking plugs that are
positioned one on the front of the cam cover and one on the
rear of the cam cover. Lift the high pressure fuel rail and
engine wiring harness to gain access.
Remove the blanking plugs and screw the locking tools into
place with the flats on the inner section of the tools horizontal.
The tools are correctly fitted when the inner section of the
tools can be easily pushed in with finger pressure.
Note:
These tools are for setting the position of the
camshafts.
Do not attempt to loosen or tighten any fixings on the
camshaft using these tools to lock the camshaft as damage
will result.
