SW-Stahl und Werkzeugvertriebs GmbH
Tel. +49 (0) 2191 / 46438-0
F
5
6
e
s
s
a
r
t
S
r
e
s
u
k
r
e
v
e
L
ax +49 (0) 2191 / 46438-40
e
d
.l
h
a
t
s
w
s
@
o
f
n
i
:l
i
a
M
-
E
d
i
e
h
c
s
m
e
R
7
9
8
2
4
-
D
Instruction Manual
BGS technic KG
Bandwirkerstr. 3
42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. (Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.) Water in the air hose
and compressor tank contributes to reduced performance and damage of the air tool. Drain the air
tank and filters before each use and as necessary to keep the air supply dry. Hose length over 25 feet
causes loss in line pressure. Increase hose ID or increase compressor pressure to compensate
for the pressure loss
.
Use an in-line pressure regulator with gauge if air inlet pressure is critical.
No.
Description
No.
Description
1
Tool
6
Oiler
2
Quick Coupler
7
Regulator
3
Air Hose
8
Water Separator
4
Quick Coupler
9
Compressor
5
Air Valve
LUBRICATION & MAINTENACE
Oil tool before each use. 4 to 5 drops
Air Tool Oil placed in the air inlet is
sufficient. Use proper air pressure and
CFM rating listed for this tool. Drain
water from hoses and compressor tank.
Water in the air supply line damage the
tool and loss of power. Clean or
replace air filters at prescribed intervals
from.
DISPOSAL
If the tool is too seriously damaged to be used anymore, drop it in a resource
recycling can.
