BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
AIR SOURCE
Clean air of correct air pressure is recommended for the power supply for this tool. A maximum of 90
PSI at the tool is recommended for most air tools of this class. Check specifications section for
recommended pressure. Depending on length of air hose and other circumstances, air pressure at
compressor may need to be increased to 100 PSI to ensure 90 PSI at the tool.
Water in the air hose and compressor tank contributes to reduced performance and damage of the air
tool. Drain the air tank and filters before each use and as necessary to keep the air supply dry. Use
an in-line pressure regulator with gauge if air inlet pressure is critical.
RECOMMENDED AIR SYSTEM
No
Description
No
Description
1
Air Tool
6
De-Watering / Filter Unit
2
Air Hose
7
De-Watering Valve
3
Quick coupler
8
Shut-Off Valve
4
Oiler
9
Dryer / Filter Unit
5
Pressure Regulator
10
Compressor / 11 De-Watering Valve
OPERATION
•
Only operate the product on compressed air systems that have the correct air pressure and
sufficient air volume (l/min) for this tool.
•
Before using the compressed air device, give 4 to 5 drops of compressed air device oil into the
compressed air connection. The performance of the device depends on the size of the air
compressor and the compressed air output volume.
•
The speed can be set via an air supply controller (not included in the scope of delivery).
•
The technical data of the tool refer to a working pressure of 6.3 bar.
•
Caution should always be exercised when using the bristle grinder. In case of negligent
operation, internal components of the device can be damaged and the work performance can be
restricted.
•
Press the operating lever (trigger) to operate the tool.
•
Release the operating lever (trigger) to stop the tool.
•
Note that the tool continues to run after the operating lever (trigger) is released.
•
Do not remove any information labels from the device and replace damaged labels.
•
Keep hands, loose clothing and long hair away from moving part of the tool.
