BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed
BGS 1930
Digital Vernier Caliper, 150 mm
ATTENTION
Read the operating instructions and all safety instructions contained therein carefully before using the
product. Use the product correctly, with care and only according to the intended purpose. Non-
compliance of the safety instructions may lead to damage, personal injury and to termination of the
warranty. Keep these instructions in a safe and dry location for future reference. Enclose the
operating instructions when handing over the product to third parties.
SAFETY INFORMATIONS
•
Do not subject the vernier caliper to shock or impact.
•
Avoid contact with water and do not immerse the vernier caliper in liquids of any kind.
•
Do not take measurements on or near objects wich is under voltage.
COMPONENTS
1
Measuring surfaces for inner measuring
2
Measuring surfaces for outer meassuring
3
Button to switch unit mm / inch
4
Button On/Off
5
Button to set 0 position
6
Locking screw
7
Digital Display
8
Battery compartment
9
Actuating wheel
10
Scale
11
Depth measuring rod
PREPARATION
1. Switch on the device by pressing the button (4).
2. Set the caliper to the smallest possible dimension, both measuring surfaces must face each other
without a gap.
3. Press button (5) to reset the vernier caliper to the value 0.
4. Select the desired unit of measurement (millimeters or inches) by briefly pressing the button (3).
