SECTION 2
INSTALLATION OF FIRE
2.1
UNPACKING THE FIRE
Carefully lift the fire out of the carton. Remove the loose item packaging carefully
from the front of the appliance. Check the contents as listed :-
Packing Check List - Coal Fuelbed Models
1off
Fire tray / burner assembly
1off
Boxed ceramic base and 14 large / 4 small synthetic coals
1off
Loose items bag.
1off
Installation / User book (Combined)
2.2
INSTALLING THE TRAY
Establish which type of flue you are intending to install the fire in to :-
225 x 225mm (9 inch x 9 inch) brick built chimneys
175mm (7 inch) diameter lined brick or stone flue, or insulated pre-fabricated
metal flue box to BS 715 / BS EN 1856-2.
A spillage test must always be carried out to check satisfactory
clearance of flue products, regardless of the type of flue the
appliance is being fitted to.
To Install the Fire Proceed as follows :-
a)
Carefully place the burner tray in the opening in the arch cast iron
fascia.
b)
Centralise the fire in the opening and mark the centres of the two fixing
holes, which are located in the front flange, below the control knob /
piezo button on the burner tray.
NOTE : If fitting the appliance to a marble or granite hearth, it may be
necessary to use the fixing location holes on the rear support of
the tray
c)
Whilst the fire is in position, decide which side the gas supply is to enter
the fire from and plan accordingly. The inlet elbow can be loosened and
rotated if necessary. See Fig. 5 & 6 on page 11 for suggested pipe
routes.
9
