3.4
REPLACING THE GLASS ASSEMBLY
3.4.1
When replacing the glass assembly manouever into position by
reversing the instruction for removal as detailed in section 2.14
3.4.2
Centre the assembly (use the legs on the surround as a guide) but take
care not to damage the surround. When fitted correctly all the glass
frame should be hidden behind the surround legs.
3.4.3
The frame is then located by a sharp upward motion and then
immediately swing the bottom glass retaining brackets (as shown in Fig.
23, section 2.14) to stop the glass frame assembly dropping.
3.4.4
If the glass frame is not high enough to locate the bottom glass
retaining brackets then a lever (e.g. screwdriver) can be used to
carefully
push the whole glass assembly into place, refer to Fig. 39
below for position of lever.
3.4.5
Finally, latch the glass clamps back into position and replace the screws
on the bottom glass retaining brackets.
Fig. 39
34
Suggested Position of lever (eg
screwdriver) to lift glass frame
assembly as necessary.