3.2.3.4
To set the P2 timed setting, press the “SET” button until the “TIMER”
mode is displayed. Hold the “SET” button until the display flashes the
current time for P1. Press the “SET” button again to scroll past the
setting for P1 (sun) and P1 (moon). The time should now be flashing
on the handset. Set the hour by pressing the “UP” (large flame) and set
the minutes (in ten minute increments) by pressing the “DOWN” (small
flame) as necessary, then press “OFF” button to complete the process.
3.2.4
Operation of the Fire in “LIGHT / DIMMER” mode (where down
lights are specified)
3.2.4.1
In order to change the mode of operation from “MANUAL” to “LIGHT /
DIMMER”, briefly press the “SET” button to scroll through to the light
bulb mode as shown below in figure 39.
3.2.4.2
Press and hold the “LARGE” flame button to turn on the light or
increase brightness.
3.2.4.3
Press and hold the “SMALL” flame button to decrease the brightness.
3.2.4.4
In the light / dimmer mode the “OFF” button shuts off the light, if you
want the light on but no flame, press and hold the “SMALL” flame button
and turn to pilot flame.
NOTE :
The light bulb is displayed during light / dimmer setting only. 8
seconds after the light/dimmer has been set, the handset will
automatically go into manual mode.
34
Fig. 39
“Light bulb”
symbol illuminated