MOD.
BZ 99
20
5 - USE OF THE MACHINE
5.1 Machine Start and Water Sup-
ply
(Fig. 04)
Turn on the water supply tap (version R).
Introduce water in the basin (fig.01; pos.14)
(version S).
Press the switch ON/OFF (pos.1).
Automatically the water is supplied to the boiler.
During this operation, the lights (9 and 10) on the
control panel are off.
At the end of the water supply, the lights (9 and
10) will be on.
Should the lights be off after the water supply,
turn on and off the switch ON/OFF till the lights
(9 and 10) light up.
5.2 Heating
(Fig. 05)
In order to have the right temperature for the ma-
chine, make sure that the pressure on the gauge
is from 1 to 1,2 bar, then turn the steam knob
(7) and let out 2 or 3 times the steam into the
drain tray.
The yellow light (fig.04; pos. 9) if on, points out
the activation of the heating element.
When the green indicator (fig.04; pos. 10), is on,
it means that the machine is working; if it is off,
it means that the level of the water is insufficient
in the boiler.
5.3 Coffee Preparation
1) Remove the filter holder (fig.01; pos. 5)from
the supply group (fig.01; pos. 4).
2) Put the ground coffee into the filter holder,
press it and make attention that the filter hol-
der edge is not dirty with coffee.
3) Replace the filter holder in its housing.
Version PM
4) Press the coffee supply key (fig.04; pos.2).
5) Press again the above key to stop the coffee
supply.
Versione DE
4)Press one of the keys of the coffee distribu-
tion keypad (fig.06) according to thedesired
dose.
Follow the instructions of paragraph 5.7 of this
booklet in order to change the doseprogram-
ming.The machine is preset for the continuous di-
stribution: press the key “PROG” (fig.06;pos. 1)
to start the distribution, press it again to stop it.
Caution:
- Do not remove the filter holder filled
with coffee when the equipment is ope-
ratingbecause it is under preassure.
- Do not touch expressly the metal plating of the
filter holder; danger of burns.
5.4 Steam Outlet
(Fig. 05)
1) In order to avoid eddies in the boiler, let off
steam by turning the relevant knob (7).
2) Insert the nozzle (Fig.01; pos. 6) into the con-
tainer with the water to be heated.
3) Turn the steam knob (7).
The outlet steam depends on the knob turning:
the more the knob is turned, the more the
steam is let off.
4) After the steam has been blown off, turn the
knob off, take out the container and clean
immediately the nozzle with a damp cloth in
order to remove residual heated water.
Caution:
Do not touch expressly the
steam nozzle; danger of burns
5.5 Getting Hot Water
1) Place the water container under the dispenser
(fig.01; pos. 3).
2) Turn on the knob (fig.01; pos. 8) to get the
required quantity of water.
Caution:
Do not touch expressly the
water dispenser; danger of burns
5.6 Machine Stop
1) Turn off the water knob (version R).
2) Press the switch (fig.01; pos. 1) and verify if
the led is off .
