Bezzera BZ09, Instruction Manual

Page: 25 / 56

25
MOD. BEZZERA BZ09
1) empty the tank,
2) unplug from power supply,
3) replace the machine in a dry, weather-resistant
environment of exclusive access.
6 - MAINTENANCE
To allow the machine to work correctly, follow the
maintenance instructions provided below.
6.1 Safety rules
Do not subject the machine to water jets. Disconnect
the machine from the electrical power by turning
the electrical power network omnipolar knife-switch
lever to the resting position 0. Remove the plug and
close the water interception tap before carrying out
maintenance and/or cleaning work. If the machine
is malfunctioning, do not attempt to repair it alone
and call the technical assistance service immediately.
If the electrical power cable has been damaged, turn
off the machine immediately, turn off the water and
call the technical assistance service. Do not replace
it alone. Carry out cleaning/maintenance when the
machine is cold, preferably wearing protective gloves.
6.2 Cleaning the machine
Warnings : For the best results and in
compliance with current regulations,
change the water contained in the
boiler and pipings at every daily startup
of the machine.
These advices are indicative, the maintenance and
cleaning schedules depend on the use of the ma-
chine.
After each use
1) Clean the steam nozzle.
2) Clean the filter holder and the filters.
Daily
1) Clean the cup holding grid and the drain basin.
2) Clean the body.
3) Clean the group’s gasket with the brush sup-
plied.
4) Wash the group as follows: hook the filter holder
with the blind filter supplied to the group) and ini-
tiate output for a few times.
5) Immerse the filter holder and the filters in hot wa-
ter for a few minutes to dissolve the grease of the
coffee, use a cloth or sponge to remove it.
For washing and cleaning operations, do
not use solvents, detergents or abrasive
sponges but only specific products for
coffee machines. Wash the body using a
cloth soaked in water and/or neutral detergents, and
dry the surfaces well prior to connect the machine to
the electric line again. Use water to wash the cup
holding grid and the drain basin.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
Replace the tank and insert the silicon tubes making
sure that the suction pipe touches the bottom.
6.3 Safety thermostat - Manual rearming
Warning! The operation described
below is only relevant to an
installing technician who is
authorised by the manufacturer.
While the machine is working, the boiler resistance
may overheat and, cutting off power, sets off the
safety thermostat that prevents any further damage
to the boiler.
Do not carry out any temporary repair and call im-
mediately the technical assistance service.
6.4 Correct product disposal
(electrical and electronic waste)
(Applicable in the European Union countries and those
countries with separate waste collection systems).
The sign carried on the product or on its
documentation indicates that the product
must not be disposed of with other
domestic waste at the end of its life cycle.
To avoid any damage to the environment or to health,
caused by unsuitable waste disposal, the user is asked
to separate this product from other types of waste and
to recycle it responsibly to help the sustainable
recycling of material resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local office
in charge of this matter for all the information relating
to separate waste collection and recycling for this type
of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.