34
Guidance and manufacturer’s declaration – electromagnetic emissions
The ApexPilot All-In-One
is intended for use in the electromagnetic environment specified below.
The customer or the user of the ApexPilot All-In-One should assure that is used in such an
environment.
Immunity test
level EN
60601-1-2
Compliance
Level
Electromagnetic environment - guide
Conducted
RF
IEC
61000-4-6
Radiated
RF
IEC
61000-4-3
3 Vrms
150 kHz to 80
MHz
3 V/m
80 MHz to 2.5
GHz
3 Vrms
3 V/m
Portable and mobile RF communications
equipment should be used no closer
to any part of the ApexPilot All-In-One,
including cables, than the recommended
separation distance calculated from the
equation applicable to the frequency of
the transmitter. Recommended separation
distance
d = 1.2
P
d = 1.2
P 80 MHz-800 MHz
d = 2.3
P 800 MHz-2.5 GHz
Where P is the maximum output power
rating of the transmitter in watts (W)
according to the transmitter manufacturer
and d is the recommended separation
distance in meters (m). Field strengths
from fixed RF transmitters as determined
by an electromagnetic site survey, should
be less than the compliance
level in each frequency range.
Interference may occur in the vicinity
of equipment marked with the following
symbol:
NOTE 1: At 80 MHz and 800 MHz, the higher frequency range applies.
NOTE 2: These guidelines may not apply in all situations. Electromagnetic propagation is
affected by absorption and reflection from structures objects and people.
a) Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless)
telephones and land mobile radios, amateur radio, AM and FM radio broadcast and TV
broadcast cannot be predicted theoretically with accuracy. To assess the electromagnetic
environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured field strength in the location in which the
ApexPilot All-In-One is used
exceeds the applicable RF compliance level above, the ApexPilot All-In-One should be observed
to verify normal operation. If abnormal performance is observed, additional measures may be
necessary, such as re-orienting or relocating the ApexPilot All-In-One
b) Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 3 V/m.
