Beurer EM34, Instruction Manual

Page: 13 / 52

13
10. Specifications
Output waveform Biphasic rectangular pulse
Pulse length 300 μs
Pulse frequency 2-60Hz or 2/100Hz
Output voltage max. 90 Vpp (500 ohms)
Output current max. 180 mApp (500 ohms)
Power supply 3 x 1.5 V AAA batteries LR03
Intensity Levels 0 to 25
Operating conditions 41 ° – 104 °F (5 °– 40 °C)
at a relative humidity of 30– 75%
Storage conditions 14 °– 131 °F (-10 °– 55 °C)
at a relative humidity of 10– 90%
Dimensions 3.3 x 2.8 x 1.2 in
(85 x 72 x 31 mm)
Weight Control unit: 2.96 oz (84 g)
including batteries
Cuff: 4 oz (113 g)
The serial number can be found on the unit itself or in the bat-
tery compartment.
11. FCC Compliance Statement
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) this device
may not cause harmful interference; and (2) this device must ac-
cept any interference received, including interference that may
cause undesirable operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential in-
stallation. This equipment generates, uses, and can radiate radio
frequency energy, and if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interfer-
ence will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to
operate the equipment.