14
RECOMMENDED MAINTENANCE
Clean Brushes
Clean the brushes on a weekly basis or when adhesive build-up effects proper
moistening of the tape. The adhesive can prevent sufficient and even water flow
to the tape causing poor moistening of the tape. Regular cleaning will extend the
life of the brushes and ensure that adhesive build-up will not cause performance
to deteriorate.
Procedure:
1.
Unplug power from the machine! Remove the water bottle and water
tank.
Caution: Heater may stay hot for a period of time after
machine is off.
2.
Remove the brushes from the tank and remove any dried adhesive
from the tank and brush. Note how brushes are set into the tank as
they must be reset properly.
3.
Wash the brushes with warm water and soap.
4.
Place the brushes back into the water tank. It is extremely important
that they are positioned correctly. Brushes must be sloped toward the
front of the dispenser in order to work properly. The top of the brushes
are cut on an angle. Shorter brushes go in the back. The longer
length bristles must be toward the front of the machine (tank).
Notice: Installing the brushes in backwards will cause
excessive tape jams. Never cut the brushes tips to remove
adhesive as they are cut at a specific angle and flagged to
facilitate proper moistening and cutting will most likely cause
poor
performance.
Cleaning the Shear Blades
When using reinforced tapes laminated with adhesive or resin, this material can
accumulate on the blades and interfere with the cutting of the tape. Even paper
tape with no reinforcement can cause an accumulation of dust and adhesive on
the blades. Use a small brush and a suitable solvent to remove accumulation.
Never scrap the cutting edge with a hard object because the blade may become
dull and need replacement.
Warning: Be sure the dispenser is unplugged before performing and
cleaning procedures.
Summary of Contents for BP500M
Page 2: ...2 ...
