6. If required attach Install the pivot pin into the end of the blind and plate to the idle end of the hood, using nut
and bolt provided.
7. If required attach gearbox to hood end cap using nut and bolt provided. The gearbox can be positioned in two
different angles. Betta Blinds and Awnings recommend the gearbox to be angled outwards for ease of use.
NB: Bolt from the outside in.
8.
Installing wire cable
- To assemble the Rapid Lock, first push and twist the wire into the 35mm Rapid Lock
stud (the longer stud) till it reaches the end. Wire needs to be twisted in the direction as shown below to avoid
fraying. Then, pull to tighten.
NOTE:
To release the wire,place release key on the wire and push it into the rapid lock stud and pull wire out
Please see Video: How to attach & remove the wire
https://www.loom.com/share/a7222d33554c4650ae89500856510d70
9. Attach the Barrel Nut to the cassette and then add the top Rapid Lock and fasten the nut, allow for extra thread
for adjustment when the bottom Rapid Lock is assembled.
10. Install Bottom L Brackets at the bottom fixing point.
