ENGLISH
TROUBLESHOOTING GUIDE
PROBLEM
CAUSE
SOLUTION
Check AC Adaptor for proper installation.
Check batteries for proper installation or replace batteries.
Switch off the sorter
, remove defective coins, switch on and tr
y again.
Remove the coins and tr
y again.
Place sorter on desk or table.
Insert batteries as Figure 1.
Replace batteries.
In rare cases, take the batteries out for 10 seconds, replace them
and tr
y again.
Slightly push the COIN TUBE DRA
WER inward until it stops.
Press the “R” button and hold for 2 seconds.
Turn coin tube to an angle that will allow the drawer to open.
AC Adaptor is not inserted correctly.
AC Adaptor is not plugged into the socket.
C Cell is not inserted correctly or needs to be replaced.
The coin jams with the wheel.
Coins are bent, worn, nicked or dirty.
Coins are bent, worn, nicked or dirty.
Sorter is not on a level sur
face.
AAA Batteries are not inserted.
AAA Batteries are inserted backwards.
AAA Batteries need to be replaced.
COIN TUBE DRA
WER is not closed properly.
Too many coins of same denomination being sorted at
one time.
Coins are stacked sideways in coin tubes.
Motor does not run when
sorter is switched ON.
Coins do not sort properly.
LCD Counter does not display
anything and/or will not count.
Coins are diverted to OVERFLOW
TRA
Y before COIN TUBES are full.
LCD blinks before reaching
€
999.99.
COIN TUBE DRA
WER will not open.
ECS-Proff-Anleitung.pdf 15.09.2004 14:20 Uhr Seite 11
