44
3. Check the functionality and connections of the brush enable microswitch,
vacuum enable microswitch, and backward enable microswitch.
When the microswitch is activated, there should be 0.5 mm of clearance
between the lever and the body of the switch. Check that the lever of the switch
operates correctly. If it is necessary to adjust the switch, follow the directions
below:
3.1. To adjust the vacuum enable switch and the backward enable switch:
• Loosen the two screws holding the switch in place
• Move the microswitch up or down on the slot until it is in the correct
position, allowing 0.5 mm of clearance between the lever of the switch
and the body of the switch.
• Tighten the screws to hold the microswitch in place.
3.2. Adjustment of brush enable microswitch:
• Loosen the two screws holding the switch in place
• Move the microswitch up or down on the slot until it is in the correct
position, allowing 0.5 mm of clearance between the lever of the switch
and the body of the switch.
• Tighten the screws to hold the microswitch in place.
ELECTRIC INSTALLATION TEST
Summary of Contents for STEALTH DRS21BT MicroRider
